| Description |
102 Actuator
Used with Troll'n Tab Kits prior to 2000
5/16" (.79 cm) mounting hardware
Stroke: 4-1/4" (10.8 cm)
Length overall: 14" (35.56 cm)
Length pin to pin: 13" (32.87 cm)
Diameter (upper housing): 2-1/2" (6.35 cm)
Mounting hardware: 5/16" (.79 cm) or Delrin Pin (Part #15087-001)
Part # (Superceded #)
# 15059-001 (102-2) 12 Volt w/6' (1.83m) leads with Deutsch connectors and mounting hardware(replacement length)
- Top cap gland seal sheaths the actuator cable outer jacket as well as both internal conductors for maximum waterproofing
- Corrosion proof Vandar mounts
- Stainless steel ram won't flex, even under extreme loads
- Double O-ring for maximum protection
- Ballscrew rotates freely on 12 ball bearings at both ends of its stroke so there's no need for complicated limit switches and clutches
- Self-locking ballscrew locks into position and will not drift
- Precision molded, powdered metal, high alloy gears provide high accuracy, high wear resistance, and high strength for long life
- Tough, high-torque motor easily transfers 750 lbs
- High-impact, ultraviolet resistant nylon 66, 50% glass fiber reinforced thermoplastic housing
- Corrosion proof Vandar cap and mount, stands up to severe loads
|
|
Shopping Cart 
